I have just replaced the front @ 12k miles, The rear lasted 6k miles (BT023) Like the grip so replaced with the same ( got a large screw in the rear at 2k so there not quite in sync ) sorry dont know the km conversion
Nice to see a run at stock to compare manufacturer figures to real world (Rear tyre) figures
Scorpion (no baffle) with stage 1 dna
Will have to scan a better copy sometime
Ive heard t-cut will take out scratches in the screen (If its knackered youve nothing to loose by trying)
dont think wet and dry will work but a buffing cloth may (Try a small corner patch to test)
MT Tour Yamaha Motor UK
Its on again
16th to 17th May - MCN Festival - East of England Showgroun, Peterborough
20th to 21st June - Ryka's Cafe - Box Hill near Dorking
4th to 5th July - Squires Cafe - Newthorpe, Leeds
11th July - Castle Coombe - Bike Safe, Chippenham
28th November to 6th...
they are homemade from cutable smd strips (£10 per 5m)
Easy (ish) to do, just soldering and cutting, joining wires
There is a writeup here extra brake lights | Yamaha MT-07 FZ-07 Forum
Any mesh will do it just clamps under the insert
£21 on yamabits for the official coloured ones Yamaha MT-07 Accessories | Genuine Yamaha Accessories for MT 07
Dont waste your money worrying about it, as it is what it is.
If you calculate the tank dimensions it will probably be close to 14lt (if its 13.5 they will round up to a whole figure) Its called creative advertising, everybody does it (They will not say, a tank that you can put 14lt of petrol In...
How many resistors did they use ? I think i remember a post somewhere that if you use 4 then it screws up the hazards (I think there should only be 2 resistors even if you replace all 4 indicators)
That is a serious issue if your dealer returned it in that state and let you ride off :/
Drop off...
No, you need either, a relay OR resistors to slow the flash rate of the LED indicator to the correct speed
Resistors = make the bike think it still has 10watt bulbs attached (they dissipate the extra energy by heat)
Relay = slows down the power on, power off cycle to the indicator
If you are...
I have similar and ive been informed there not to bright when followed (seem bright enough to me though) also mine are not e marked so may need changing before an mot.
The relay is under the left hand side panel and the relay is £12 on ebay ( relay is better than resistors) Link Here (edit - is...
Im using the innovv c3
power from the aux connector (via twin 5v usb converter) the reccoder units sit under the pillion seat and the camera head - front behind grill - rear behind footplate (limited view) so just moved it to the (inside) top of the passenger footrest (more visible but better...
Thankyou for them kind words good sir.
I was lucky as they had it in transit but i still had to wait 6 weeks for it, and they were long long weeks ;)
Stay safe and be seen on them dark nights https://picasaweb.google.com/116109553843724488593/Mt07BrakeLights?authuser=0&feat=directlink
Theres no real need to remove the battery bar but it does make it easier to see the plastic rivets
A little tip for the center top clips
For the clip nearest the seat - press down on the centre piece as you lift the side panel
For the one nearest the filler cap - lever the clasp you can see...